Changes for Z 6 Firmware v.1.01 & Z 7 Firmware v.1.03:
When On is selected for HDMI > Advanced > N-Log setting in the SETUP MENU, Maximum sensitivity now takes effect during movie recording if:
The camera is in mode P (programmed auto), S (shutter-priority auto), or A (aperture-priority auto), or
The camera is in mode M (manual) and On is selected for ISO sensitivity settings > Auto ISO control (mode M) in the MOVIE SHOOTING MENU.
Fixed an issue that resulted in third-party software showing an incorrect value for the Exif 35 mm format equivalent focal length field for photographs taken with a non-CPU lens connected via an FTZ mount adapter with the focal length specified using the Non-CPU lens data item in the SETUP MENU.
Fixed an issue that resulted in photographs taken using radio-controlled Advanced Wireless Lighting being overexposed if a face was detected with Auto-area AF selected for AF-area mode.
Additional changes for Z 6 Firmware v.1.01:
Fixed an issue that resulted in an incorrect aperture being selected in mode P (programmed auto) with a flash mounted on the camera under conditions in which f/32 would normally be selected.
Fixed an issue which prevented flash units controlled via radio Advanced Wireless Lighting syncing with shutter speeds of 1/100 s or faster with:
On selected for Flicker reduction shooting in the PHOTO SHOOTING MENU and
Enable selected for Custom Setting d5 (Electronic front-curtain shutter) in the CUSTOM SETTING MENU.