Nikon WR-R10 2.00 Firmware Update Available

From Nikon:

Modifications enabled with this firmware upgrade

  • Camera settings can now be viewed and changed using the WR-1 when the WR-1 is used as a transmitter and the WR-R10 is connected to a D7100 for use as a receiver.
  • Support for the Release Hold Time function built into the WR-1 is now supported when the WR-1 is used as a transmitter and the WR-R10 is used as a receiver.
  • To make remote operation using the WR-1 function that allows for division of multiple units into groups (A, B, C, D) more convenient, the group specified with the WR-R10 is now fixed at group A rather than all groups (A, B, C, D) with transmission. With reception, the group is fixed at group A with firmware versions 1.00 and 2.00.
  • The following cameras can be used at this time to upgrade the WR-R10 firmware: D7100

Only the camera(s) indicated above can be used to upgrade WR-R10 firmware. Firmware updates can also be perfomed for you at Nikon service centers.

Confirming the firmware version

  1. Connect the WR-R10 to a camera
  2. Turn on the camera
  3. Press the camera's MENU button and select Firmware version from the setup menu.
  4. The WR-R10's firmware version will be displayed with a "W".
  5. Turn off the camera.

Download the Nikon WR-R10 2.00 firmware update: Windows | Macintosh

Firmware installation instructions (English, PDF): Windows | Macintosh

B&H carries the Nikon WR-R10 Wireless Remote Controller Transceiver.

Posted: 3/14/2013 8:13:47 AM ET   Posted By: Sean
Posted to: Nikon News    Category: Nikon Firmware Updates
Share on Facebook! Share on X! Share on Pinterest! Email this page to a friend!
Send Comments
Terms of Use, Privacy  |  © 2024 Rectangular Media, LLC  |  Bryan CarnathanPowered by Christ!